Impact VC-500WLN-II 500Ws Digital Monolight - Manual (Page 20)

20
Remote Instructions
Impact’s VC-500WL3KN-II three-light kit comes with a
2.4 GHz transmitter that enables the user to control and
trigger the studio flash remotely. (The VC-500WLXMT
transmitter can be purchased separately.)
Mount the transmitter onto your camera’s hot shoe or
connect it using the included 3.5 mm to PC sync cord.
Adjusting Flashtube Power
Press the or button on the remote to adjust the
power output of the flashtube. Each push of the button
will adjust the output in 0.1 increments.
Set the modeling light to proportional mode (see page 15), and the buttons will
also adjust the modeling light power in 0.1 increments.
Operating the Modeling Light
To turn on the modeling light, press and hold the button for three seconds. The
modeling light will automatically set to Free mode.
If the modeling light is set to proportional mode, press and hold the button to
switch to free mode.
Once free mode is activated, immediately press the and buttons to adjust
the modeling light power in whole increments.
After three seconds of inactivity, the and buttons return to the function of
adjusting the flash output in 0.1 increments.