Impact VC-500WLN-II 500Ws Digital Monolight - Manual (Page 4)

4
Precautions ⚠
• DANGER: high-voltage parts
inside.
• There are no serviceable parts
inside the unit. Only qualified
service engineers should access
the inside of the casing.
• If the flash tube becomes cracked
or damaged in any way, replace
immediately.
• Keep this product away from
water and any flammable gases
or liquids.
• Use only the correct,
recommended voltage.
• Avoid rapid, high-power flashing.
• Excessive heat shortens the life
span of flash tubes and internal
components.
• If the unit is not used for two
months, turn it on for 30 minutes,
and fire the flash several times to
charge the capacitors.
• Always remove the protective cap
before plugging in or powering on
the unit.
• Never operate the flash with the
protective cap on.
• Make sure this product is
powered off when plugging it into
a power source.
• Turn off the power and unplug the
power cord from the unit and wall
when the monolight is not in use.
• Always attach the protective cap
when transporting the unit.
• Do not attempt to disassemble
or repair this product. There
are components inside that can
produce a hazardous electric
shock.
• Handle this product with care.
• Do not stare at the lights when
they are powered on.
• Clean this product with only a soft,
dry cloth.
• Always wear cotton gloves when
handling the flashtube.
• Keep this product away from
children.
• Make sure everything is secure
before proceeding.
• Make sure that this product
is intact and that there are no
missing parts before use.
• Do not block, cover, or restrict the
air vents when the unit is in use.
• All images are for illustrative
purposes only.