Audio-Technica ATH-ANC300TW QuietPoint Noise-Canceling True Wireless In-Ear Headphones - Manual (Page 12)

11
Connecting via Bluetooth
When connecting a new Bluetooth device, you need to pair it with the product. Once the Bluetooth device and the
product are paired, you do not need to pair them again. The product supports multipairing, in which a connection
history is saved.
However, in the following cases you will need to pair again even if the Bluetooth device was paired once:
• If the product is deleted from the Bluetooth device’s connection history.
• If the product is sent out for repair.
• If you pair from the Bluetooth device after pairing once, “R_ATH-
ANC300TW” or “L_ATH-ANC300TW” may be displayed. You can
select either one to pair, but “R_ATH-ANC300TW” is recommended.
• When switching to a Bluetooth device, you may not be able to
pair because the previously connected Bluetooth device cannot be
disconnected. In such cases, place the headphones into the charging
case (with battery level remaining for the case) and press and hold
(about 6 seconds) the multifunction button on the R (right) side. The
indicator lamps on both the L (left) and R (right) light in red. After
lighting in red, the product will switch to the “searching for devices”
state and you will be able to pair with your desired Bluetooth device.
About pairing