About this guide, Who should use this guide, How to use this guide – Enterasys Networks 7S4280-19-SYS User Manual
Page 17
Enterasys NAC Controller Hardware Installation Guide xv
About This Guide
This guide provides an overview, installation and troubleshooting instructions, and specifications
for the 2S4082‐25‐SYS and 7S4280‐19‐SYS Enterasys NAC Controller.
For information about the CLI (Command Line Interface) set of commands used to configure and
manage the NAC Controllers, refer to the Enterasys Networks™ DFE‐Platinum and Diamond Series
Configuration Guide.
For information about the technical considerations for the planning and design of the Enterasys
Network Access Control (NAC) solution, see the NAC Design Guide.
Who Should Use This Guide
This guide is intended for a network administrator who is responsible for installing and setting up
the Enterasys Network Access Controller.
How to Use This Guide
Read through this guide completely to familiarize yourself with its contents and to gain an
understanding of the features and capabilities of the Enterasys NAC Controllers. A general
working knowledge of data communications networks is helpful when setting up these systems.
This preface provides an overview of this guide and the Enterasys NAC Controller manual set,
and a brief summary of each chapter; defines the conventions used in this document; and instructs
how to obtain technical support from Enterasys Networks. To locate information about various
subjects in this guide, refer to the table on the following page.
Note: In this guide, the following terms are used:
•
Enterasys NAC Controller and NAC Controller refer to the system
•
NAC refers to the Network Access Control function in your network
•
PEP refers to Policy Enforcement Point
•
NAC Controller PEP refers to the module installed in the N1 chassis which together
make up the Enterasys NAC Controller
•
NAC Controller Engine refers to a daughter card unit installed in the NAC Controller
that provides the access control connectivity and software.
Electrical Hazard: Only qualified personnel should install or service this unit.
Riesgo Electrico: Nada mas personal capacitado debe de instalar o darle servicio a esta unida.
Elektrischer Gefahrenhinweis: Installationen oder Servicearbeiten sollten nur durch
ausgebildetes und qualifiziertes Personal vorgenommen werden.