Enterasys Networks 7S4280-19-SYS - Manual (Page 45)

Installing NAC Controller PEP into the Matrix N1 Chassis
Enterasys NAC Controller Hardware Installation Guide 4-5
Removing the Mini-GBIC
To remove a Mini‐GBIC from a port slot, proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the Mini‐GBIC.
2. Remove the cables connected to the Mini‐GBIC.
3. Release the Mini‐GBIC from the port slot. Refer back to the appropriate figure listed below to
locate the release mechanism and proceed as instructed.
– For the type of Mini‐GBIC shown in Figure 4‐1 , push in on the release tab as far as it will
go to release the Mini‐GBIC.
– For the type of Mini‐GBIC shown in Figure 4‐2 , pull out on the release tab to release the
Mini‐GBIC.
– For the type of Mini‐GBIC shown in Figure 4‐3 , pull down on the wire handle to release
the Mini‐GBIC.
4. Grasp the sides of the Mini‐GBIC and pull it straight out of the port slot.
If storing or shipping the Mini‐GBIC, insert its dust protector to protect its fiber‐optic ports.
Installing NAC Controller PEP into the Matrix N1 Chassis
A 2S4082‐25 or 7S4280‐19 NAC Controller PEP can be installed in the single horizontal slot of the
N1 chassis. To install a module into the Enterasys Matrix N1 chassis, refer to
Figure 4‐4 and use
the installation procedure as defined below:
Caution: Do NOT remove a Mini-GBIC from a slot without releasing the locking tab located under
the front bottom end of the Mini-GBIC
. This can damage the Mini-GBIC.
The Mini-GBIC and its host device are sensitive to static discharges. Use an antistatic wrist strap
and observe all static precautions during this procedure. Failure to do so could result in damaging
the Mini-GBIC or host device. Always leave the Mini-GBIC in the antistatic bag or an equivalent
antistatic container when not installed.
Precaución: NO quite el Mini- GBIC de la ranura sin antes abrir la traba ubicada en la parte
frontal del Mini- GBIC.
Si lo hace, puede dañar el Mini- GBIC, puesto que es muy sensible a las descargas de
electricidad estática, al igual que el dispositivo host. Utilice la pulsera antiestática y tome todas las
precauciones necesarias durante este procedimiento. Si no lo hace, pude dañar el Mini- GBIC o
el dispositivo host. Mientras no esté instalado, mantenga el Mini- GBIC en su bolsa antiestática o
en cualquier otro recipiente antiestático.
Caution: Failure to observe static safety precautions could cause damage to the NAC Controller
PEP. Follow static safety handling rules and wear the antistatic wrist strap.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the board or
components can cause damage.
Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de
electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad para la
manipulación del producto y no olvide utilizar la pulsera antiestática.
No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto cortante
entra en contacto con la placa o con los componentes, éstos podrían dañarse.