Enterasys Networks 7S4280-19-SYS - Manual (Page 46)

Installing NAC Controller PEP into the Matrix N1 Chassis
4-6 NAC Controller PEP Installation
Preparation
1. Remove the blank panel covering the slot in which the module will be installed. (Save the
blank plate in the event you need to remove the module.)
2. Remove the module from the shipping box. (Save the box and packing materials in the event
the module needs to be reshipped.)
3. Locate the antistatic wrist strap shipped with the chassis. Attach the antistatic wrist strap to
your wrist and plug the cable from the antistatic wrist strap into the ESD grounding receptacle
at the upper right corner of the chassis.
4. Remove the module from the plastic bag. (Save the bag in the event the module must be
reshipped.) Observe all precautions to prevent damage from Electrostatic Discharge (ESD).
5. Examine the module for damage. If any damage exists, DO NOT install the module.
Immediately contact Enterasys Networks. Refer to “
Getting Help” on page xviii .
Installation
To install the NAC Controller PEP, refer to Figure 4‐4 and proceed as follows:
1. Locate the chassis card guides as shown in Figure 4‐4 on page 4‐7. Make sure the module
locking levers are in the open position (top and bottom).
2. Align the module card between the upper and lower card guides of the desired slot and slide
it into the chassis, taking care that the module slides in straight. See Caution below.
3. Slide the module into the slot until you can engage the top and bottom locking levers.
4. Refer to the Caution note above, then rotate the two levers into the closed position.
5. If the chassis in which the module is installed was powered down for the installation, turn the
power supplies on. Check to see that the module CPU LED settles at solid green after a few
minutes. If the LED does not turn solid green, refer to
Chapter 5 for troubleshooting details.
Caution: To prevent damaging the backplane connectors in the following step, take care that the
module slides in straight and properly engages the backplane connectors.
Ensure that the top lever lines up with the desired slot number located on the front panel of the
chassis. Refer to
Figure 4-4 .
Precaución: Para evitar que se dañen los conectores del panel posterior en el siguiente paso,
intente deslizar el módulo en forma recta y verifique que se enganche correctamente en los
conectores de panel posterior.
Asegúrese de que la palanca superior esté alineada con respecto al número de ranura
correspondiente ubicado en el panel frontal del chasis. Consulte en
Figure 4-4 .
Caution: Due to the amount of force needed to properly seat the NAC Controller PEP connectors
into the backplane connectors, it is best to apply force to the end of the levers to insert (or eject) the
module. Otherwise, damage could result to the module and chassis.
Precaución: Para colocar los conectores del módulo en los conectores del panel posterior
correctamente es necesario hacer bastante fuerza, por ello, para insertar o quitar el módulo, se
recomienda concentrar la fuerza en el extremo de las palancas. Si no lo hace, podría dañar el
módulo y el chasis.
Caution: In step 4, do not force the locking levers to the point that they touch the face of the front
panel. Forcing the locking levers to this point could damage the module and chassis.
Precaución: En el paso 4, tenga cuidado de no llevar las palancas de cierre a un punto en donde
estén en contacto con el panel frontal. Si lo hace, podría dañar el módulo y/o el chasis.