Installation and operation, cont’d – Extron electronic Wall and Floor Box Mountable Interfaces RGB 468 Mxi User Manual

Page 14

Advertising
background image

RGB 460xi Series • Installation and Operation

Installation and Operation, cont’d

2-4

a

Faceplate screws — These screws secure the faceplate to the rest

of the interface.

C

Do not remove these faceplate screws while the
interface is attached to the wall or the detached
interface may fall down inside the wall.

b

Power/signal LED — This LED lights

Yellow to indicate the interface is receiving power.

Green to indicate that an active sync signal is present at the

input and the interface is receiving power.

N

If the input signal has sync on green, the LED will not
change from yellow to green

c

No Monitor/Monitor switch (video input termination) —

Select one of the following video input impedance selections to

provide the best picture:

No Monitor (75 ohms) if no local monitor is connected or if

the picture is too bright or blooming (unterminated).

• Monitor (high impedance) if a local monitor is connected, a

laptop breakout cable is used, or if the picture is too dark.

d

Audio input connector — Plug

a 3.5 mm stereo plug into this

jack for unbalanced audio input.

Wire the male plug as shown on

the right.

e

Computer input connector

— Attach a cable from the

computer to the interface via this female 15-pin HD connector.

f

Buffered local monitor output connector — Attach a cable from

a local monitor to this female 15-pin HD connector.

g

Horizontal shift control knob (H. Shift) — While viewing the

displayed image, rotate this control to move the image to the

right or left on the screen. The Min/Max LED (h) flashes red

whenever the minimum or maximum limit of this control is

reached.
N

DDSP disables the horizontal shifting control.

h

Min/Max LED — This LED blinks red momentarily whenever

the minimum or maximum limits of the horizontal shift control

(g) have been reached. Continually turning the horizontal

shift control knob in the same direction after the limit has been

reached causes the LED to continually blink.

Tip (+)

Sleeve ( )

Sleeve ( )

Ring (-)

Tip (+)

Audio Plugs.eps

RCA Connector

3.5 mm Stereo Plug Connector

(balanced)

Sleeve ( )

Ring (R)

Tip (L)

3.5 mm Stereo Plug Connector

(unbalanced)

Advertising