Extron electronic Wall and Floor Box Mountable Interfaces RGB 468 Mxi - Manual (Page 26)

RGB 460xi Series • Specifications, Parts, and Accessories
Specifications, Accessories, Part Numbers
A-2
Video
Gain........................................................ Unity (0.7 V), 15% with 3 dB peaking (0.8 V),
30% with 6 dB peaking (0.9 V)
Bandwidth ............................................ 300 MHz (-3 dB)
Video input and loop through
Number/signal type .......................... 1 analog RGBHV, RGBS, RGsB
Connectors ........................................... 1 female 15-pin HD buffered input connectors
and
1 female 15-pin HD local monitor loop through
connectors
Nominal level ....................................... 0.7 Vp-p for RGB
Minimum/maximum levels .............. Analog: 0.3 V to 1.45 Vp-p with no offset at
unity gain
Impedance ............................................ 75 ohms or Hi Z, switchable (set to 75 ohms if
no local monitor is connected)
Horizontal frequency .......................... 15 kHz to 150 kHz (optimum: 15 kHz to 62 kHz)
Vertical frequency ................................ 30 Hz to 170 Hz
Return loss ............................................ <-30 dB @ 5 MHz
Video output
Number/signal type .......................... 1 analog RGBHV, RGBS, RGsB
Connectors ........................................... 5 BNC female on 2” to 2.5” cables
Nominal level ....................................... 0.7 Vp-p for RGB
Minimum/maximum levels .............. Analog: 0.7 V to 0.9 Vp-p (switch selectable) w/
peaking and 0.7 Vp-p input
Impedance ............................................ 75 ohms
Return loss ............................................ -30 dB @ 5 MHz
Sync
Input type ............................................. Autodetect RGBHV, RGBS, RGsB (accepts RGsB
but does not strip from video)
Output type .......................................... RGBHV: at all times
RGBS: switch selectable
RGsB: switch selectable or pass-through
Input level ............................................. 2.0 V to 5.5 Vp-p with +0.2 VDC offset max.
Output level .......................................... 4.0 V to 5.0 Vp-p, unterminated
Input impedance .................................. 510 ohms
Output impedance ............................... 75 ohms
Max. propagation delay ...................... 52 ns
Max. rise/fall time ............................... 2.5 ns
Polarity .................................................. Positive or negative
Specifications