Sachtler aktiv14T Touch & Go Fluid Head with SpeedLevel & 7-Step Drag (100mm) - Manual (Page 24)

22
Operation
Additional C of G Adjustments
If it is not possible to correctly set the payload C of G using the
standard method:
1 . Move the camera plate to offset the payload further in the required
direction.
2 . Use the C.O.G plate (# 1063) which is available as an accessory
for the Touch & Go models.
Adjusting the Counterbalance
The fluid head is equipped with a 15 + 0 step counterbalance adjuster
to accurately balance the payload.
Moving the counterbalance from one setting to another
requires the head to pass the horizontal position to take affect.
1 . Set the counterbalance adjustment knob to the mid-range setting.
2 . Tilt the payload approximately 30° in both directions and release
it. If the payload stays in the same position when released, the
payload is correctly balanced.