Sachtler aktiv14T Touch & Go Fluid Head with SpeedLevel & 7-Step Drag (100mm) - Manual (Page 32)

30
General Notices
UK Declaration of Conformity
Vitec Production Solutions Ltd . declares under our sole responsibility that the product detailed in this manual
conforms with all relevant provisions of the following UK Regulations:
The Electromagnetic Compatibility Regulations 2016
The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012
A copy of the declaration is available on request .
-------
EU Declaration of Conformity
Vitec Production Solutions Ltd . declares under our sole responsibility, supported by Vitec Product Solutions GmbH
- our authorized representative, that the product detailed in this manual conforms with all relevant provisions of the
following EU directives:
Electromagnetic Compatibility Directive 2014/30/EU
RoHS 2011/65/EU
A copy of the declaration is available on request .
------
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules . Operation is subject to the following two conditions:
1 . This device may not cause harmful interference .
2 . This device must accept any interference received, including interference that may cause undesired operation .
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules . These limits are
designed to provide reasonable protection against harmful interference in a residential installation . This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications . However,
there is no guarantee that interference will not occur in a particular installation . If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna .
• Increase the separation between the equipment and receiver .
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help .
Modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment under FCC rules.
-----
Vitec Production Solutions Ltd . declares that this product has been manufactured in accordance with BS EN ISO9001 .