EnGenius Technologies ENH500 - Manual (Page 50)

8 LAN Setup
This section will guide you to setup the Local Area Network (LAN) settings
8.1 IP Settings
This section is only available for Non-Router Mode. IP Settings allows you to configure the IP
settings of the ENH500.
IP Network Setting Select Radio button for Obtain an IP address automatically or
Specify an IP address.
IP Address Specify LAN port IP address.
IP Suet Mask Specify Subnet Mask.
Default Gateway Specify Default Gateway.
Primary DNS Specify Primary DNS.
Secondary DNS Specify Secondary DNS.
Accept / Cancel Press Accept to confirm the changes or Cancel to return
previous settings.
Please make note of the following:
1. Obtain an IP address automatically is not a DHCP server. This setting allows the
ENH500 to automatically request an IP address when it is connected to a device which
has a DHCP server.
2. Changing LAN IP Address will change LAN Interface IP address. The webpage will
automatically redirect to the new IP address after Apply is selected.