Epson LQ-570e - Manual (Page 6)

EPSON LQ-570e
6 - EPSON LQ-570e 4/00
230 V
Safety standards EN 60950
EMI EN 55022 (CISPR pub. 22) class B
AS/NZS 3548 class B
Acoustic noise Approx. 49 dB (A) (ISO 7779 pattern)
CE Marking
230 V
Low Voltage Directive 73/23/EEC EN 60950
EMC Directive 89/336/EEC EN 55022 Class B
EN 61000-3-2
EN 61000-3-3
EN 50082-1
IEC 60801-2
IEC 60801-3
IEC 60801-4
Control Panel Buttons and Lights
Font button
Selects the font.
Font lights
Indicate which font is selected.
Condensed button
Turns condensed mode on and off.
Condensed light
On when condensed mode is on.
Tear Off/Bin button
❏ Advances continuous paper to the tear-off position.
❏ Feeds continuous paper backward from the tear-off position
to the top-of-form position.
❏ Selects a cut-sheet feeder bin when the cut-sheet feeder
is installed and the release lever is in the single sheet
position.
❏ Turns on the card mode to print on postcards and
envelopes.
Tear Off/Bin lights
❏
f f when continuous paper is in the tear-off position.
❏
o n when bin 1 of the optional cut-sheet feeder is selected.
❏
n o when bin 2 of the optional cut-sheet feeder is selected.
❏
n n when the printer is in the card mode.
n = on, o = off, f = flashing
LF/FF button
❏ Feeds paper line by line when pressed quickly.
❏ Ejects a single sheet or advances continuous paper to the
next top-of-form position when held down.
Load/Eject button
❏ Loads a single sheet of paper.
❏ Ejects a single sheet of paper when a sheet is loaded.
❏ Loads continuous paper from the standby position.
❏ Feeds continuous paper backward to the standby position in
micro adjust mode.
Micro Adjust mode
When you hold down the Pause button for 3 seconds, the
printer enters the micro adjust mode. In this mode, you can
press the
LF/FF D and Load/Eject U buttons to adjust the
top-of-form or tear-off position.
Pause button
Stops printing temporarily, and resumes printing when pressed
again. When pressed for 3 seconds, turns on micro adjust mode.
Pause light
❏ On when the printer is paused.
❏ Flashes when the printer is in the micro adjust mode or
when the print head has overheated.
Paper Out light
❏ On when no paper is loaded in the selected paper source or
paper is not loaded correctly.
❏ Flashes when paper has not been fully ejected or a paper jam
has occurred.