Electrolux L 56840 - Manual (Page 29)

1. Open the porthole and extract the inlet
hose.
2. Connect the hose with the angled con-
nection to the machine.
Do not place the inlet hose downwards.
Angle the hose to the left or right de-
pending on the position of your water tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied with
the appliance.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Installation should comply with local water
authority and building regulations require-
ments. Check the minimum water pressure
required for safe operation of the appliance in
the chapter "Technical Data".
Installation 29