Electrolux L 56840 - Manual (Page 8)

1. Pull out the dispenser drawer until it
stops. Measure out the amount of deter-
gent required, pour it into the main wash
compartment and, if you wish to carry
out the prewash phase or to perform the
stain function, pour the detergent or the
stain remover into the compartment
marked .
2. If required, pour fabric softener into the
compartment marked (the amount
used must not exceed the MAX mark in
the drawer). Close the drawer gently.
Select the required programme by means of programme selector dial (1)
You can choose the right programme for any type of laundry following the descriptions on
the washing programme tables (see «Washing Programmes»).
Turn the programme selector dial to the required programme. The programme selector
determines the type of washing cycle (e.g. water level, drum movement, number of rinses)
and the washing temperature according to the type of laundry.
The pilot light of button 5 starts blinking.
The selector dial can be turned either clockwise or anticlockwise. Position to Reset
programme/ Switching OFF of the machine.
At the end of the programme the selector dial must be turned to position , to
switch the machine off.
If you turn the programme selector dial to another programme when the machine is work-
ing, the yellow pilot light of button 5 will blink 3 times to indicate a wrong selection. The
machine will not perform the new selected programme.
Select the SPIN speed or the RINSE HOLD option (Button 2)
When the required programme has been selected, your appliance automatically proposes
the maximum spin speed provided for that programme.
8 Daily use