Epson DELTA 28-276 - Manual (Page 15)

15 - English
ATTACHINg THE TABLE TO THE SAW
1. Remove the band saw blade.
2. Align the two table studs (A) Fig. 19 in the bottom
of the table with the two holes in the trunnion
assemblies (B).
NOTE: Confirm that the slot (C) Fig. 19 is facing toward
the front.
3. Place an M13 flat washer on the table stud and
thread the table knob on the table stud.
4. Repeat this process for the remaining table stud.
ATTACHINg BLAdE TO THE SAW
NOTE: The 14" band saw uses 93-1/2" length blades.
1. Remove the table pin (A) Fig. 20 from the table.
2. Open the two wheel guard doors (B) Fig. 20 and the
blade guard door (C).
3. Confirm that the quick tension lever (D) Fig. 20 is
positioned to the left of the machine.
NOTE: Install the blade with the teeth pointing down,
toward the table.
4.
Slide the band saw blade, (teeth facing out), through
the slot (E) Fig. 20 in the band saw table.
5. Place the blade around the two wheel assemblies (A)
Fig. 21.
6. Replace the table pin (A) Fig. 20.
7. Close the two wheel-guard doors (B) Fig. 20 and the
blade guard door (C).
8. Move the quick tension lever (D) Fig. 20 to the right .
9. See the section
"OPERATINg CONTROLS ANd
AdJUSTMENTS" to adjust the blade tension and
tracking.
A A
B B
A
C
B
B
A
E
C
d
A
B
C
TABLE INSERT
Place the table insert (A) Fig. 22 in opening of table.
NOTE: A tab (B) on the insert fits into the notch (C) in
table opening.
Insert the motor plug (A) Fig. 18B into the receptacle (B)
of the switch-to-motor cord.
Fig. 18B
A
B
CONNECTINg MOTOR CORd TO SWITCH ASSEMBLY
Fig. 19
Fig. 20
Fig. 21
Fig. 22
disconnect the machine from the power source!
disconnect the machine from the power source!
disconnect the machine from the power
source!