Epson DELTA 28-276 - Manual (Page 16)

16 - English
STARTINg ANd STOPPINg THE SAW
Make sure that the switch is in the
“OFF” position before plugging cord into outlet. do
not touch the plug’s metal prongs when unplugging
or plugging in the cord
The power switch is located on the left side of the
machine. To turn the machine
"ON", push the green
start button (A) Fig. 23. To turn the machine "OFF", push
the red stop button (B).
LOCKINg THE SWITCH IN THE "OFF" POSITION
IMPORTANT: When the tool is not in use, the switch
should be locked in the
"OFF" position to prevent
unauthorized use, using a padlock (Fig. 24) with a 3/16"
diameter shackle.
In the event of a power outage (such
as a breaker or fuse trip), always move the switch to
the “OFF” position until the main power is restored.
TILTINg THE TABLE
You can tilt the band saw table 45 degrees to the right
and 10 degrees to the left.
1. To tilt the table to the right, loosen the two locking
knobs (A) Fig. 25, tilt the table to the desired angle
as shown on the scale (D) Figs. 25 and 26, and
tighten two locking knobs (A).
2. To tilt the table (C) Fig. 26 to the left, loosen the two
locking knobs (A) Fig. 25 and tilt the table to the right
until you have access to the table stop (A) Fig. 26.
Remove the table stop (A) Fig. 26, and tilt the table
to the left 10 degrees. Tighten the two locking knobs
(A) Fig. 25.
A
A
d
C
A
B
d
E
F
A
B
OPERATION
OPERATIONAL CONTROLS ANd AdJUSTMENTS
Fig. 23
Fig. 24
Fig. 25
Fig. 26