RCF HDL10-A 1400W Dual 8" Active Line Array Module (Black) - Manual (Page 11)

11
ENGLISH
- fly bar angles;
- angles from cabinets to cabinets. If one of the cited variables change the safety factor
MUST BE recalculated using the software before rigging the system.
In case the fly bar is picked up from 2 motors make sure that the fly bar angle is correct. An
angle different from the angle used in the prediction software can be potentially dangerous.
Never allow persons to stay or pass under the system during the installation process.
When the fly bar is particularly tilted or the array is very curved the centre of gravity can
move out from the rear links. In this case the front links are in compression and the rear
links are supporting the total weight of the system plus the front compression. Always
check very carefully with the “RCF Shape Designer” software all this kind of situations
(even with a small number of cabinets).
THE MAXIMUM NUMBER OF SPEAKERS THAT MAY BE SUSPENDED USING
THE HDL20-A FRAME IS:
n° 16 HDL20-A;
n° 8 HDL18-AS;
n° 4 HDL 18-AS + 8 (EIGHT) HDL 20-A USING ACCESSORY LINK BAR HDL20-HDL18-AS
THE MAXIMUM NUMBER OF SPEAKERS THAT MAY BE SUSPENDED USING
THE HDL10-A FRAME IS:
n° 16 HDL10-A;
n° 8 HDL15-AS;
n° 4 HDL 15-AS + 8 (EIGHT) HDL 10-A USING ACCESSORY LINK BAR HDL10-HDL15-AS
MAXIMUM ARRAY SIZE
THE HDL FLY BAR FEATURES: FRONT FLYING BRACKET. Front mounting.
QUICK LOCK PIN HOLE. Front mounting (to be used to lock the front bracket before
installation).
FRONT BRACKET - TRANSPORT HOLES.
CENTRAL PICK UP POINTS.
The pickup point is asymmetric and can be fit in two positions (A and B).
A position brings the shackle towards the front.
B position allows an intermediate step using the same fixing holes.
Move the pickup bracket in the position suggested by RCF Shape Designer.
Fix the pickup bracket with the two pins on the bracket’s lanyard to lock the pickup.
1
1
2
2
3
3
4
5
6
7
4
THE HDL FLY BAR
A B