RCF HDL10-A 1400W Dual 8" Active Line Array Module (Black) - Manual (Page 18)

18
ENGLISH
The RCF Easy Shape Designer software is divided into two macro sections: the left part of
the interface is dedicated to project variables and data (size of audiences to cover, height,
number of modules, etc.), the right part shows the processing results.
At first the user should introduce the audience data choosing the proper pop-up menu
depending on the size of the audience and introducing the geometrical data. It is also
possible to define the height of the listener.
The second step is the array definition selecting the number of cabinets in the array, the
hanging height, the number of hanging points and the kind of available flybars. When
selecting two hanging points consider those points positioned at the flybar extremes.
The height of the array should be considered referred to the bottom side of the flybar, as
shown in the picture below.
After entering all the data input in the left part of the user interface, by pressing the
AUTOSPLAY button the software will perform:
- Hanging point for the shackle with A or B position indicated if a single pickup point is
selected, rear and front load if two pickup points are selected.
- Flybar tilt angle and cabinet splays (angles that we have to set to each cabinet before
lifting operations).
- Inclination that each cabinet will take (in case of one pick up point) or will have to
take if we were to tilt the cluster with the use of two engines. (two pick up points).
- Total load and Safety Factor calculation: if the selected setup doesn’t give Safety
Factor > 1.5 the text message shows in red color the failure to meet the minimum
conditions of mechanical safety.
- Low Frequency Presets (a single preset for all the array) for RDNet use or for rear
panel rotary knob use (“Local”).
- High Frequency Presets (a preset for every array module) for RDNet use or for rear
panel rotary knob use (“Local”).
HEIGHT