Enterasys Networks Enterasys SecureStack A2 A2H124-48P - Manual (Page 71)

Using the Reset Password Switch
SecureStack A2 PoE Installation Guide 4-9
Using the Reset Password Switch
If you forget the SecureStack A2 login password, use the Reset password switch as
described in the following procedure.
Figure 4-3 Reset Password Switch
To reset the SecureStack A2 password, refer to Figure 4‐3 and proceed as follows:
1. Press‐and‐hold the Reset Password switch while the switch is operational. This
change of the login password to the default password will be indicated via Local
Management CLI only. This information will not show up in a Telnet session.
2. Logon to switch management. You can now logon to the switch via the Console port
and assign a new password using the command line interface (CLI).
3. To access switch management from your local PC, terminal, or modem connection,
refer to the SecureStack A2 Configuration Guide for instructions on how to log in and
enter a new password. The guide is available online under the S category for
Securestack at:
http://www.enterasys.com/support/manuals
If you require assistance, contact Enterasys Networks using one of the methods described
in “
Getting Help ” on page 1‐7.
1 Reset password switch
Note: Notify the system manager before changing the password.
Console
CPU
RPS
MGR
А