Exergen TEMPORALSCANNER TAT-5000 - Manual (Page 26)

Care and Maintenance
Instructions for Fahrenheit or Celsius Conversion
The TemporalScanner can be used in either °F or °C. To convert from one scale
to the other, the only tool necessary is a paper clip or the tip of a small screwdriver.
For °F/°C Conversion:
• Loosen single screw on bottom of case and
remove battery cover.
• Lift battery out of the way.
• Locate the little switch to the right of the
battery as indicated in the drawing, and with
the tip of the paper clip or screwdriver, slide up
or down to the opposite position.
• Remove the paper clip or screwdriver.
• Replace battery and cover.
Switch
o F
o C
DISPLAY DIAGNOSTICS CHART
The following chart summarizes the fault conditions, and the associated indications:
Condition Display Range
High Target
Low Target
High Ambient
Low Ambient
Low Battery
Dead Battery
Processing Error
HI
LO
HI A
LO A
bAtt
blank display
Err
>110 o F (43 o C)
<61 o F (16 o C)
>104 o F (40 o C)
<60 o F (16 o C)
Restart. Return
to Exergen for
repair if error
message
persists.
24
818528r5:818528r5.qxd 4/24/2008 11:05 AM Page 26