Operation and service information – E-Z-GO ST 480 User Manual

Page 22

Advertising
background image

OPERATION AND SERVICE INFORMATION

3-14

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings

The oil should be changed in accordance with the Periodic Service
Schedule while the engine is warm. See SERVICE AND MAINTE-
NANCE for checking oil level and changing oil procedures.

COLD STARTING

Starting a cold engine may require use of the choke. Depress the
accelerator approximately 1" (2.5 cm) or until the starter just begins to
operate. Pull the choke out if required. Accelerate slowly and push the
choke in completely when the engine runs smoothly.

Do not allow the starter to operate
con ti nu ousl y fo r mo re t han 1 0

s ec on ds . Al l ow 3 0 se co n ds b e twe en st art i ng
attempts. If the vehicle does not start on the third
attempt, turn the key switch off, set the park brake and
determine the cause of the problem.

If the vehicle had been running and the engine does not start within 10
seconds, use the choke.

STARTING AND DRIVING

To reduce the possibility of roll-back
which could result in severe injury
or vehicle damage, do not release

the service brake until engine has started.

To operate vehicle:

• Apply the service brake, place the key in the key switch and turn it

to the ‘ON’ position.

• Move the direction selector to the direction desired.

• Release the park brake by pressing the release button in the end

of the handle while slightly raising the handle. Then lower the

parking brake handle.

• Slowly depress the accelerator pedal to start the engine. Release

service brake when engine starts.

• When the accelerator pedal is released, the ignition circuit is de-

energized and the engine stops. To stop the vehicle more quickly,
depress the service brake pedal.

When the direction selector is in the reverse posi-
tion, a warning signal will sound to indicate that the

vehicle is ready to run in reverse.

STARTING THE VEHICLE ON A HILL

To reduce the possibility of roll-back
which could result in severe injury
or vehicle damage, do not release

the service brake until engine has started.

Do not hold vehicle on hill by using
the accelerator and engine. This will

cause premature and excessive wear to drive train
components.

To reduce the possibility of permanent damage to the drive system, it is
important to prevent excessive roll-back when starting the vehicle on a
hill.

Place left foot on service brake and release the park brake. Depress
accelerator with right foot and release the service brake by lifting left
foot.

COASTING

To reduce the possibility of severe
injury or death from coasting at

!

!

!

!

!

!

Advertising