E-Z-GO ST 480 - Manual (Page 26)

OPERATION AND SERVICE INFORMATION
3-18
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
VEHICLE CARE PRODUCTS
To help maintain the vehicle there are several products available
through local Distributors, authorized Branches, or the Service Parts
Department.
• Touch-up paint specially formulated to match vehicle colors for
use on both metal and molded plastic bodies. (P/N 28140-G** and
28432-G** for solid colors; 75831-G** for camouflage colors)
• Battery Protectant formulated to form a long-term, flexible, non-
tacky, dry coating that will not crack, peel or flake over a wide tem-
perature range. (P/N 75500-G01)
• White Lithium Grease designed to provide lubrication protection in
areas where staining or discoloring is a problem, or in areas of
extreme temperature ranges. (P/N 75502-G01)
• Penetrant/Lubricant, a 4-in-1 product that penetrates seized parts,
lubricates leaving a light lubricating film, reduces corrosion by
adhering to wet or dry surfaces and displaces moisture, sealing
against future moisture return. (P/N 75503-G01)
• Multi-purpose Cleaner and Degreaser that contains natural, envi-
ronmentally safe solvents. (P/N 75504-G01)
• Multi-purpose Hand Cleaner is an industrial strength cleaner con-
taining no harsh solvents, yet gently lifts grease off hands. May be
used with or without water. (P/N 75505-G01)
• Battery Cleaner that neutralizes battery acids and dissolves termi-
nal corrosion and can be rinsed with water. (P/N 75506-G01)
• Biodegradable Cleaner that breaks down grease to be easily
wiped or rinsed away. (P/N 75507-G01)
• Multi-purpose Value Pack sampler includes 4 ounce (118 ml)
aerosol cans of Battery Protector, Penetrant/Lubricant, White Lith-
ium Grease, and Carburetor and Choke Cleaner. (P/N 75508-
G01)
• Plexus
®
plastic cleaner and polish removes minor scratches from
windshield. (P/N 28433-G**)
REPAIR
LIFTING THE VEHICLE
Tool List Qty. Required
Floor jack ...............................................................................1
Jack stands............................................................................4
Chocks...................................................................................4
To prevent possible injury or death
resulting from a vehicle falling from
a jack, be sure the vehicle is on a
firm and level surface. Never get under a vehicle while it is
supported by a jack. Use jack stands and test the stability of
the vehicle on the stands. Always place chocks in front and
behind the wheels not being raised. Use extreme care since
the vehicle is extremely unstable during the lifting process.
Some servicing operations may require the rear wheels or the entire
vehicle be raised.
Install chocks in front and behind each front wheel (Ref Fig. 16 on page
3-19). Center jack under rear bumper. Raise vehicle and locate a jack
stand under the outer end of each rear axle.
Lower jack and test the stability of the vehicle on the two jack stands.
! !