Electrolux EDC47130W - Manual (Page 9)

electrolux use 9
In both cases the Start/Pause button flashes
to remind you that the start button needs to be
pressed again.
Indicator lights
These lights indicate the following functions:
Drying light
This light indicates that the appliance is in the
drying phase.
Cooling light
This light indicates that the appliance is in the
cooling phase. At the end of drying, there is a
10 minute cooling phase to cool the laundry.
End/Anticrease light
This light is on at the end of the cooling phase,
during the anti-creasing phase and at the end
of the program.
Condenser light
It comes on every 80 cycles to remind you
that the condenser must be cleaned.
Filter light
This light illuminates at the end of the program
to remind you that the filters must be cleaned.
Water Tank light
This light comes on at the end of the program to
remind you that the water tank must be emptied
out. If this light illuminates during a program
this means that the water tankis full. The buzzer
sounds, the program stops, the Start/Pause
button flashes. This light comes on also when
the water tank is not inserted correctly.
At the end of the program
All drying programs end with a 10 minute
cooling phase.
You may remove the laundry after this phase.
The lights Filter and Water Tank illuminate.
The display shows a static zero.
If the laundry is not removed at the end of
the cycle, the dryer performs an anticreasing
phase (duration: 30 minutes maximum). If you
do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing
phase. Lights Filter and Water Tank
remain
lit and the buzzer sounds for 2 minutes.
Turn the program selector dial to “O” to switch
the machine off. Remove the laundry from the
drum and carefully check that the drum is empty.
If you open and then close the door before
turning the selector dial to “O” all the lights
corresponding to the phases making up
the performed program come on.
After each use
• Clean the filters.
• Empty the water tank.
Modifying the program
To change a program which is running, first
cancel it by turning the program selector dial
to “O”. Select the new program and press the
Start button .
EMAN_EDC4713OW_Feb09.indd 9 16/3/09 11:26:46 AM