Elektra Beckum TKHS 315 P - Manual (Page 7)

19
ENGLISH
2. Attach cable with cable tie (32) to
the motor carrier unit.
A
Caution!
Make sure the cable does not
run over sharp edges and is not bent.
Riving knife adjustment.
A
Danger!
For shipping the riving knife is
is lowered beneath the table top's
surface. Prior to initial operation the
riving knife therefore needs to be
adjusted:
−
in the distance to the saw blade;
−
in its lateral alignment.
Distance to the saw blade:
The distance between the saw blade's
peripheral edge and the riving knife shall
be between 3...8 mm.
The riving knife must project at least the
same distance over the saw table as the
saw blade.
1. If necessary, loosen the Keps nut
(33) on the riving knife one turn.
2. Adjust distance of the riving knife to
the saw blade.
3. Tighten the Keps nut.
Lateral alignment:
riving knife and saw blade must be per-
fectly in line.
•
Turning the four hexagon socket
head cap screws (34) on the motor
carrier unit below the saw table
clockwise
= riving knife is moved to the right.
•
Turning the four hexagon socket
head cap screws (34) on the motor
carrier unit below the saw table
counter-clockwise
= riving knife is moved to the left.
4. Fit table insert extrusion (35) flush
into the saw table.
5. Turn the countersunk screw (36)
counter-clockwise against the stop.
Installing the dust collection gear
1. Install blade guard (37) on the riving
knife (38).
2. Push one end of the suction hose
(39) on the blade guard's suction
port (40).
3. Fit other end of the suction hose to
the dust extraction port (41) on the
chipcase.
4. Attach the hose carrier (42), with the
larger opening pointing to the rear,
to the saw table. To do so, loosen
the screws of the right-hand rear leg
and tighten again with the hose car-
rier in position.
5. Hook the suction hose into the hose
carrier.
6. Connect the saw's dust extraction
port at the chip case to a suitable
dust collector (see "Dust collector" in
chapter "Operation").
Mitre fence assembly
1. Slide the lower fence carrier (43)
onto the guide bar (44) as illus-
trated.
2. Install a mounting bracket (45) using
a hexagon head screw (46) and ser-
rated lock washer (47) to both ends
of the guide bar.
3. Attach guide bar with mounting
brackets to front and rear of the
table top:
−
Put two each hexagon head
screws (46) with fitted washers
(48) throught the holes from the
outside;
30 31
32
33
Item Description Qty.
37 Blade guard 1
39 Suction hose 1
42 Hose carrier 1
34
35
36
37 38
Item Description Qty.
43 Fence carrier, lower 1
44 Guide bar 1
45 Mounting bracket 2
46 Hexagon head screw
M8 x 16 6
47 Serrated lock washer
8.4 2
48 Washer 8.4 7
49 Flange nut M8 4
50 Fence carrier, upper 1
51 Star-knob screw
M8 x 23 1
52 Fence extrusion,
short 1
53 Knurled nut M6 2
39 40
42
41
43
44
45
46
47