Elektra Beckum TKHS 315 P - Manual (Page 8)

20
ENGLISH
−
from the inside screw on flange
nuts (49) – do not yet tighten
fully.
4. Align guide bar exactly parallel with
the table top's edge.
5. Tighten all screws of mounting
brackets and guide bar.
6. Swing the lower fence carrier up.
7. Install the upper fence carrier (50)
with washer (48) and star-knob
screw (51).
8. Install the short fence extrusion (52)
using two each knurled nuts (53)
and washers (48):
−
the wide edge of the fence extru-
sion must face the workpiece
−
the plastic nose of the fence
extrusion must point towards the
saw blade.
3
Note:
When the mitre fence is not
required swing it down, out of the way.
Table extension installation
1. Put guide bar (54) into the extension
table (55) as illustrated.
2. Screw a hexagon thin nut (56) onto
the guide bar.
3. Install the rear table extension, with
the guide bar fitted to the table top's
rear edge left side.
4. Screw another hexagon thin nut (56)
onto the guide bar from inside, to
hold it to the table top.
5. Put a hexagon head screw (57) from
the narrow side through the plastic
guide bar bracket (58) and slide
plastic guide bar bracket onto the
guide bar.
6. Fasten the plastic guide bar bracket
to the table top, using a flange nut
(59).
3
Note:
When folded up the surface of
the extension table must not be higher
than the table top's surface. Otherwise a
workpiece can get stuck at the extension
table.
7. Adjust the hexagon thin nuts (56) on
the guide bar until the guide bar is
exactly parallel with the edge of the
table top.
8. Tighten the hexagon thin nuts
against each other.
9. Fasten supports (60) with one each
hex. socket head bearing screw
(61), washer (62) and hexagon nut
(63) to the extension table.
10. Insert the supports into the slots pro-
vided in the short stanchion at the
rear of the saw.
11. If required, secure each support with
one each hexagon head screw (64)
and flange nut (59) on the rear short
stanchion.
12. Tighten all hexagon head screws
and flange nuts of the saw's stand.
Accessory holder installation
In a final assembly step, two hexagon
head screws are fitted as holders for the
push stick, push block handle and
assembly wrench to the right front leg:
1. Turn one each flange nut approx.
10 mm on the two hexagon head
screws (65).
2. Fit one hexagon head screws in the
hole at the front of the leg and
secure it with another flange nut.
46
48
49
50
48
51
52
53 48
Item Description Qty.
54 Guide bar, long 1
55 Plate, table rear
extension 1
56 Hexagon thin nut
M12 2
57 Hexagon head screw
M6 x 50 1
58 Plastic bracket 1
59 Flange nut M6 3
60 Support 2
61 Hex. socket head
bearing screw
M8 x 15 2
62 Washer 8.4 2
63 Hexagon nut M8 2
64 Hexagon head screw
M6 x 16 2
54
55
56
57 58
59
Item Description Qty.
65 Hexagon head screw
M6 x 50 2
– Flange nut M6 4
60
61
62 63
64
59