Empire Comfort Systems CIDV-30-7 - Manual (Page 20)

Page 20 R-5086
Replacement of Gasket on Glass Panes (Figure33)
1. Remove casing top from outer casing.
2. Remove casing front from outer casing.
3. Lower valve cover on firebox.
4. Release two door latches at bottom of firebox.
5. Grasp bottom of glass frame, pull forward until bottom of glass
frame is removed from glass frame guide and pull downward until
glass frame is removed from glass frame support top.
6. Place glass frame assembly on a non-abrasive surface. The exterior
of the glass frame assembly should be facing the non-abrasive
surface.
7. Remove the (6) screws on the glass frame assembly.
8. Remove the (2) 1" x 13-3/4" divider brackets from the glass frame
assembly.
9. Remove the gasket that is to be replaced on the glass pane. Clean
the glass pane before the new gasket is attached.
10. Remove the backing material from the gasket.
11. Starting in a corner of the glass pane, place the gasket over the edge
of the glass pane. The gasket should be equally divided between
the front and back of the glass. Continue to attach the gasket until
the four edges of the glass pane are gasketed.
12. When the glass panes are replaced into the glass frame assembly,
the corner of the glass pane where the gasket was started and ended
should be placed to the bottom of the glass frame assembly.
13. Replace and attach the (2) 1" x 13-3/4" divider brackets onto the
glass frame assembly with the (6) screws from Step 7.
14. Grasp bottom of glass frame, push upward and insert glass frame
into glass frame support top, push inward and insert glass frame
into glass frame guide.
15. Attach two door latches to bottom of firebox.
16. Replace casing front onto outer casing.
17. Replace casing top onto outer casing.
18. Replacement of gasket on glass panes is completed.