Empire Comfort Systems CIDV-30-7 - Manual (Page 7)

Page 7 R-5086
to protect the porcelain finish. The exterior of the porcelain
casting pieces should be facing the non-abrasive surface.
2. The assembly of the casting is accomplished in 6 stages:
A. Attaching legs to the sides (Figure 7).
B. Attaching rear cover to sides (Figure 8).
C. Removing protective packaging from casing front and window
(Figure 9).
D. Assembly of front by attaching retaining tabs and placing front
on unit (Figure 10).
E. Inserting firebox into partially completed assembly (Figure 11
and Figure 12).
F. Placing top on unit.
Detailed Instructions Follow
3. Refer to Figure 7, the leg pads will have the letter "A" and "B"
stamped into the metal. Place leg pad "A" and leg pad "B" at the
bottom of each casing side. Leg pad "A" attaches to the front of the
casing side, right and to the rear of the casing side, left. Leg pad "B"
attaches to the rear of the casing side, right and to the front of the
casing side, left. Position the 3/4" flange on the leg pad against the
(2) locator dimples on the casing side. The 3/4" flange must be
facing upward, toward the top louver openings on the casing side.
Attach the two rear leg pads to the casing sides with (2) 3/8" bolts.
Attach but do not completely tighten the two front leg pads to the
casing sides with (2) 3/8" bolts. Attention: The front leg pads can
be adjusted to provide a snug fit between the casing front and the
casing sides.
4. Attach (4) leveling bolts to the bottom of the (4) legs.
5. Align the 3/8" hole at the top of the leg with the 3/8" hole in the leg
pad. Attention: For proper positioning of the leg to the leg pad the
(2) 1-1/2" top edges of the leg must be placed flush and parallel to
the (2) edges on the leg pad. Attach leg to leg pad by inserting (1)
1" bolt through the leg pad and into the leg, secure bolt with 1/4"
nut.
6. Insert (2) 3/8" bolts into the (2) holes on the edges of the casing
sides. The bolts should only be threaded half-way into the holes in
order to allow for clearance when the casing back is attached to the
casing sides.
Figure 7
7. Refer to Figure 8, attach casing support to rear cover with (4) 10 x 1/2"
screws. The rear cover has (4) keyholes for attachment to the casing
sides. Stand the casing sides on the floor with the (2) bolts attached half-
way into the edges of the rear cover positioned at the rear. The large
diameter holes in the keyholes of the rear cover will be toward the floor.
Working with one casing side at a time, place the large diameter holes
in the keyholes over and behind both of the bolts at the same time. Push
downward on the rear cover to lock the keyholes into position behind the
bolts. Finish tightening both bolts to secure rear cover to casing side.
Repeat this procedure to secure rear cover to the second casing side.
Figure 8