Enviro 828 DV.INS. - Manual (Page 4)

2 . DIMENSIONS AND CLEARANCES TO COMBUSTIBLES
FIREPLACE INSERT:
The stove can only be installed in a solid fuel burning fireplace .
Mantle pillar to stove 10”
Stove top to 8” wide mantle 12”
Minimum firebox size W 26” x H 20” x D 20”
(NOTE; standard size shown – optional 33”H x 46”W available)
FREESTANDING:
Side wall to stove 10"
Rear wall to stove
4"
Combustible to stove Top 22"
Floor to stove
0"
Corner clearance
2"
Alcove depth
48"
Maintain sufficient clearances for service and maintenance
FIREPLACE INSERT / WITH ZERO CLEARANCE KIT ( Part # 828- 134 )
After deciding where to locate the fireplace insert you must frame an opening to except the Zero Clearance Box to reduce the clearance to
combustibles. The framing dimensions are as follows; 32 1/4” wide, 29 3/8” high and a depth of 14 3/4”.
The header at the top front of the opening must be a 2x4 on edge or a cut out in the 2x4 to maintain clearances to combustibles to the vent
pipe. A minimum of 1 1/2” clearance must be maintained to the vent pipe.
Before you install the Zero
Clearance Box you must
determine the finished hearth
height.(including tiles, subfloor, etc.)
The bottom of the box must be the
same height as the finished
hearth height.
4