Echo PRO ATTACHMENT SERIES PAS-265 - Manual (Page 6)

6
equIpment
wArning
Use only ECHO approved attachments for Pro Attachment Series TM models. Serious injury may result from the use
of a non-approved attachment combination. Read and comply with all safety instructions listed in this manual and
attachment manual.
wArning
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all
openings.
• ALWAyS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.
• DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
• NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.
An Emission Control Label is located on the engine. (This is an EXAMPLE ONLY, information on label varies by
engine FAMILY).
NOTE
ECHO, INC. will not be responsible for the failure of cutting devices, attachments, or accessories which have not
been tested and approved by ECHO for use with this Pro Attachment Series TM .
• Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.
• Inspect guards for damage and ensure that they are securely in place. Replace if guard is damaged or missing.
• Check that the attachment is firmly attached and in safe operating condition.
wArning
Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or leaks are found,
do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an autho-
rized servicing dealer before using.
PRODUCT EMISSION DURAbILITy (EMISSION COMPLIANCE PERIOD)
The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emis-
sions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as
listed in the Maintenance Section of this manual.
e
mIssIon
c
ontrol
(
eXhaust & evaporatIve
)
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM/TWC (Engine Modification and 3-way Catalyst) and for the fuel tank
the Control System is EVAP (Evaporative Emissions) or N (for nylon tank). Evaporative emission may be applicable to
California models only.