Extron Electronics MSW 4V SDI rs - Manual (Page 19)

MSW 4V SDI rs • Specifications, Part Numbers, Accessories
Specifications, Part Numbers, Accessories, cont’d
MSW 4V SDI rs • Specifications, Part Numbers, Accessories A-2 A-3
Specifications
Video — MSW 4V rs, MSW 4SV rs
Gain ................................................ Unity
Bandwidth
MSW 4V ..................... 300 MHz (-3 dB)
MSW 4SV .................... 250 MHz (-3 dB)
Crosstalk ........................................ <-60 dB @ 3.58 MHz
Switching speed ............................ 20 ms (max.)
Video — MSW 4V SDI rs
Resolution....................................... 8 or 10 bits, automatic
Operation standards ..................... 143 Mb/s (4fsc NTSC)
177 Mb/s (4fsc PAL)
270 Mb/s (4:2:2) component video
360 Mb/s (4:2:2) widescreen, autoselect
Equalization and reclocking ........ Automatic for up to -30 dB of cable loss
Automatic data rate clock ............ Yes
Video input
Number/signal type
MSW 4V rs ......................... 4 composite video
MSW 4SV rs ....................... 4 S-video
MSW 4V SDI rs .................. 4 serial digital component video
Connectors
MSW 4V rs, MSW 4V SDI rs
4 female BNC
MSW 4SV rs ....................... 4 female 4-pin mini DIN
Nominal level ................................ 1 Vp-p for Y of S-video and for
composite video
0.3 Vp-p for C of S-video
0.8 Vp-p for SDI
Minimum/maximum levels (MSW 4V rs, MSW 4SV rs)
0.4 V to 2.0 Vp-p with no offset
Impedance ..................................... 75 ohms
Return loss
MSW 4SV rs ...................... <-25 dB, DC @ 10 MHz
Other models ..................... <-40 dB, DC @ 10 MHz
DC offset (max. allowable)........... 5.0 V
Input coupling
MSW 4V rs, MSW 4SV rs . DC
MSW 4V SDI rs .................. AC
Video output
Number/signal type
MSW 4V rs ......................... 2 composite video
MSW 4SV rs ....................... 1 S-video, 1 composite video
MSW 4V SDI rs .................. 2 reclocked SMPTE-259 serial digital
component video
Connectors
MSW 4V rs, MSW 4V SDI rs
2 BNC female
MSW 4SV rs ....................... 1 BNC female, (1) 4-pin mini DIN female
Nominal level ................................ 1 Vp-p for Y of S-video and for
composite video
0.3 Vp-p for C of S-video
0.8 Vp-p for SDI
Minimum/maximum levels (MSW 4V rs, MSW 4SV rs)
0.4 V to 2.0 Vp-p
Impedance ..................................... 75 ohms
Return loss
MSW 4V/4SV rs ................ <-30 dB @ 5 MHz
MSW 4V SDI rs .................. <-25 dB @ 5 MHz
DC offset ........................................ ±5 mV maximum with input at 0 offset
Switching type (MSW 4V rs/4SV rs) Vertical interval
MSW 4V SDI rs
Jitter ..................................... <2 µs
Rise/fall time (20-80%) .....700 ps ±100 ps
Re-clocking ......................... Automatic, bypass mode for nonstandard
rates
Sync
Standards
MSW 4V rs, MSW 4SV rs . NTSC 3.58, NTSC 4.43, PAL, SECAM
MSW 4V SDI rs ................. SMPTE-259M, SMPTE-292M
Control/remote — switcher
Serial control port ......................... 1 RS-232, 3.5 mm captive screw connector,
5 pole
Baud rate and protocol ................. 9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configurations . 1 = TX, 2 = RX, 3 = GND