Extron Electronics MSW 4V SDI rs - Manual (Page 4)

MSW 4V SDI rs • Quick Start Guide QS-1
Quick Start Guide — MSW 4V SDI rs
Installation
Step 1
Turn all of the
equipment off and
disconnect it from
the power source.
Step 2
Select your
mounting
option, install
the appropriate
brackets and mount the
MSW. Otherwise, install
the four rubber feet (included)
and place the mini SDI switcher
on a desktop.
Step 3
Connect the video input cable(s) using
SDI video inputs 1 through 4. See “Rear Panel Connections” in
chapter 2, “Installation and Operation”.
Step 4
Attach the video output cable(s). Connect up to two SDI output
devices to the MSW.
N Outputs A and B output an identical signal.
Step 5
If the MSW is to be connected to a computer or host controller for
remote control, connect the host’s RS-232 cable to the provided 5-pole
captive screw connector, then connect it to the RS-232 port on the
mini SDI switcher (see the serial port pinout on page 2-5).
(2) 4-40 x 3/16" Screws
Use 2 mounting holes on
opposite corners.
1U Rack Shelf
1/4 Rack Width False Front
Face Plate
A/V S WIT CHE R
AUTO SW ICH MOD E NOR MAL AUTO 1 2 3 4
A/V S WIT CHE R
AUTO SW ICH MOD E NOR MAL AUTO 1 2 3 4
A/V S WIT CHE R
AUTO SW ICH MOD E NOR MAL AUTO 1 2 3 4
A/V SW ITCHE R
MOD E NOR MAL AUTO
AUTO SWIT CH 1
2
3 4
MS W 4V SD I rs
PO WER 12V .5A MA X
1
2
3
4
CO NTA CT
1 2 3 4
A
B
S D I
I
N P U T S 1
2
A
B
S D I
O
U T P U T S
RS- 232
Tx Rx
Extron
MSW 4V SDI rs
Switcher
Digital Camcorder
Digital Broadcast
VCR
Digital Broadcast
VCR
Control System