Energy Tech Laboratories EH-01-03 - Manual (Page 13)

Any question, please call CUSTOMER SERVICE 1-866-454-2588 Model:EH-01-03
13
The Active Carbon Filter (Dust Filter) is placed inside the Air inlet, you can open the Air inlet to
clean the Active Carbon Filter (Dust Filter) or replace with a new one
.
Dust filter behind
“air inlet”
Honeycomb Filter:
Protected by the Active Carbon Filter (Dust Filter), the Honeycomb Filter can be used for a long
period.
The honeycomb filter is a permanent filter and does not need to be replaced. If you live in an
area that has water that is unusually hard or has a high mineral content you must use water
additives to solve the problem. Commercial de-scaling, de-mineralizing, PH balancing, and
water softening are widely available. As these issues are highly regionalized, please consult a
local water company or pool supply company how to best treat.
Replacement of your Honeycomb filter:
If you have not used commercial water treatment additives and start to notice the performance
of your
Comfort Mist is not as good as when new, you may need to clean or replace the filter.
Residual pollutants are left as residue in the bottom of the tank. Once a week you should
remove the tank when it is out of water and wash/wipe out the tank with a damp cloth.
To remove the honeycomb filter you must turn off front panel power switch. When the unit has shutoff,
turn the Main Power Switch to “off” position, then unplug the unit from the wall outlet.
It is imperative that the unit is unplugged or serious harm or death from electrical shock can occur.
Cage Panel with 8 screws Honeycomb filter behind the Cage Panel.
4 screws on the left, 4 screws on right Remove the 8 screws to take out the filter