Energy Tech Laboratories EH-01-03 - Manual (Page 9)

Any question, please call CUSTOMER SERVICE 1-866-454-2588 Model:EH-01-03
9
To turn the unit off press the POWER button again. If you do not intend to use the unit for
some time also turn off the Main Power Switch (rocker type) on the left side near the top. After
the unit has stopped, empty the water tank.
Warmed Comfort Mist Humidification:
Turn the unit off at the Main Power Switch (rocker type) located on the left side near the top, and
be sure to remove the plug from the wall power outlet.
Fill the Water Tank with clean water. DO NOT add ice cubes in the Top Ice compartment.
Connect the unit to the power supply and turn on the Main Power Switch (rocker type) located
on the left side near the top to “on” position.
Press the front panel power button, the unit will operate in “fan only mode”
Press the MODE button to select WARM mode. The “WARM” indicator will light up. The “HUM”
indicator under HEATING button also light up as the unit gives warm air and humidity
simultaneously.
Press the HEATING button to select your desired warm air level; HIGH or LOW.
Press the SPEED button to select your desired fan speed.
Press OSCILLATE to select your preferred air flow direction, e.g. air swing from left to right, or
fixed direction of air flow
Check water level in water tank during operation. Once water below minimum level, turn off
power button and Main Power Switch. Then refill the water tank with fresh water in the tank.
Please refer to procedures to fill up water tank.
To turn off the unit, press the POWER button again. If you do not intend to use the product for
some time also turn off the Main Power Switch after the product has stopped. Empty the water
tank after turning off the Main Power Switch.
NOTE:
This unit is built with Automatic Humidistat Control. You can set your desired RH% (Relative Humidity
%) by pressing the HUMIDITY button. The adjustable range is from RH 30% to RH 70%. The RH% will
be adjusted in unit of 5%.
When the room RH (Relative Humidity) has been brought up to your set RH%, the unit will stop
humidifying function. When the room RH% drops below your set RH%, the unit will restart humidifying
function automatically. Air washer function is working whenever water is pumping through the system.
If you do not set RH%, the unit is preset at RH 50%. The adjustable range is RH 30% to RH 70%.
Humidifying is suggested for use while the RH% is below 20% as such low humidity level can be
unhealthy and uncomfortable. The recommended humidity level is 40% to 50%. This unit gives a cool,
invisible moisture output. It is normal not to see the mist.
TIMER OPERATION
The Timer can be used to switch the unit off after a selected number of hours.