Ecom Instruments x.com 400/401 - Manual (Page 25)

90
Alert activation
You can activate the Alert with this menu
LWP: This alarm is automatically activated if the mobile phone detects a
danger associated with a position without response.
GPS: Is used for the activation of the GPS module in order to send the position with the alarm.
The Voluntary Call is a persistent active alarm that is activated by pressing the emergency key.
Alert configuration
You can activate the alarms with this menu
In the Settings menu, first select Customise and then Alert.
Angle: Enables the configuration of input and discharge angles of the alarm mode.
2 parameters to be configured:
- Input angle in alarm mode
- Discharge angle of the alarm mode (< input angle with a difference of at least 20°).
Pre-alarm: Enables the configuration of the period of time during which you must respond
between the moment when the mobile phone exceeds an input angle in alarm mode and the
moment when the local alarm is started. The phone vibrates in order to incite you to respond. If
you don’t respond, the phone activates the local alarm. 2 parameters to be configured:
- Timer: Duration of the pre-alarm period (in seconds).
- Vibration: activates or deactivates the vibration during the pre-alarm
Local alarm: Enables the configuration of the phase of the local alarm during which the phone
sends a signal in order to incite you to respond.
If you still don’t respond, the phone activates the remote alarm. 2 parameters to be configured:
- Beep: activates or deactivates the signal tone during the local alarm.
- Timer: Duration of the local alarm (in seconds).
BAL x.com 401_UK.indd 90 08.01.2008 10:00:12 Uhr