Eagle Electronics Cuda 128 Portable User Manual
Page 24
20
3. Slip your saw blade into the starter hole and then cut along the
outside line. Be careful when working around the corners, because
there is little room for error.
4. Remove the backing from
one side of the double-sided mounting tape
contained in the mounting kit. Apply it to the outer ledge on the back
of your unit. Starting at the bottom center, work the tape around all
four sides of the unit. Cut off any excess tape when finished.
5. Attach the power/transducer cable to the back of the unit.
6. Remove the backing from the exposed side of the tape. Carefully
place the unit into the dash cutout. Press down firmly around the
entire outer edge to make sure the unit is secured to the dash.
In-dash mounting template for Cuda 128 and Cuda 168. NOTE: This figure
is
not printed to scale. See the back of this manual for a scaled template
copy you can tear out and use. Manual is available on our web site.
Top
ALWAYS VERIFY DIMENSIONS.
Cut along this line