Eagle Electronics Cuda 128 Portable - Manual (Page 50)

46
press PWR to clear the menu. Repeat the above steps to turn the alarm
back on, but press UP ARROW to select O
N
before clearing the menu.
Depth Alarms
The depth alarms are triggered only by the bottom signal. No other
echoes will activate these alarms. The depth alarms consist of a shallow
and a deep alarm. The shallow alarm sounds an alarm tone when the
bottom goes shallower than the alarm's setting. The deep alarm sounds
a tone when the bottom goes deeper than its setting. Both alarms adjust
the same way, although through different menus.
Shallow Alarm
To set the shallow alarm depth, press MENU DOWN
repeatedly until S
HALLOW
A
LARM
appears.
Press UP ARROW to increase the shallow alarm's depth
setting or press DOWN ARROW to decrease it. The number in
the shallow alarm’s menu box shows the current shallow
alarm setting. When the number reaches the desired setting, press PWR
to clear the menu. When the bottom depth goes shallower than the
alarm’s setting, an alarm tone sounds and a message box appears on
the screen.
Press PWR to silence the alarm. This turns the alarm sound off until
the shallow alarm is triggered again.
To turn the alarm off, press MENU DOWN repeatedly until S HALLOW
A LARM
appears. Press DOWN ARROW until the words O FF F EET
appear,
then press PWR to clear the menu.
Deep Alarm
To set the deep alarm depth, press MENU DOWN repeatedly
until D EEP A LARM
appears.
Press UP ARROW to increase the deep alarm's depth setting
or press DOWN ARROW to decrease it. The number in the
deep alarm’s menu box shows the current deep alarm