Eiki LC-XB23C - Manual (Page 55)

55
This symbol on the nameplate means the product
is Listed by Underwriters Laboratories Inc. It is
designed and manufactured to meet rigid U.L.
safety standards against risk of fire, casualty and
electrical hazards.
Appendix
The CE Mark is a Directive
conformity mark of the European
Community (EC).
Some displays are not seen –Check the Display function. (See page 41.)
during the operation.
PIN code dialog box appears at start-up. –PIN code lock is being set. Input a PIN code (1234 or
numbers you have set). (See page 18, 46, 47.)
Computer 2 cannot be selected. –Select Computer 2 at the Terminal function. (See page 44.)
The Terminal function cannot be selected. –The Terminal function cannot be selected after Computer 2 is
selected. Select other input source such as Computer 1 or
Video with the INPUT button on the top control, the
COMPUTER button or the VIDEO button on the remote
control so that the Terminal function can be selected.
The Remote Control does not work. –Check the batteries.
–Make sure no obstruction is between the projector and
remote control.
–Make sure you are not too far from the projector when using
the remote control. Maximum operating range is 16.4’ (5m).
–Make sure the code of the remote control is conformed to
the projector. (See page 45.)
–Unlock Key lock for the remote control in the Key lock
function. (See page 46.)
Cooling fans are still running after –This is normal condition. Fans are running about 1
the AC plug is disconnected. minute even after disconnecting the AC plug.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Give the model number and explain about the problem. We will advise you
how to obtain service.
Appendix