Eclipse - Fujitsu Ten AVN5495 EN - Manual (Page 10)

- 10 -
Notes on installation
• Check the vehicle speed pulse signal, parking brake signal and reverse signal carefully before making
the connections. If the cables are incorrectly connected, accidents or problems with correct operation
may result.
• The label on the vehicle speed pulse signal cable contains a protection circuit, so do not cut the cable
or remove the protective circuit, otherwise problems with operation may result.
• Bind the cables together with tape so that they do not cause an obstruction while driving. If they
become wound around parts such as the steering wheel, shifting lever or brake pedal, accidents may
result.
The locations where the vehicle speed pulse signal cable, parking brake signal cable and reverse cable
come out vary depending on the vehicle model and grade. Ask the place of car dealer or your nearest
Eclipse dealer for details.
Tip
Connecting the v Connecting the v ehicle speed pulse signal, ehicle speed pulse signal,
par par king br king br ak ak e cab e cab le and re le and re v v erse cab erse cab le le
- An example for connecting the vehicle speed pulse signal cable -
Use a splicing connector to connect the vehicle
speed pulse signal cable (purple/white) coming
from the main unit to the vehicle speed pulse
signal cable of the vehicle.
1
Route the vehicle speed pulse signal cable to the
main unit.
2
Vehicle speed pulse
signal cable (vehicle harness)
Engine computer
Vehicle speed pulse
signal cable
(purple/white) of
AVN unit harness
Contains a protective circuit
so never remove.
Splicing connector 7
Always be sure to connect the vehicle speed
pulse, otherwise the measurement precision will
be greatly reduced.
Tip