Emerson MS9923TT - Manual (Page 22)

21
T o r e c o r d f r o m t h e T u r n t a b l e :
1.) Press the FUNCTION Selector to the “AUX/PHONO” mode.
2.) Select the part of the record for recording.
3.) Press the RECORD Key on Tape Deck A to start recording.
4.) Press the “STOP/EJECT” Key and place the Tonearm on the rest when
finished.
IMPORTANT NOTES:
Never try to force the RECORD key. If it will not stay down, this means that one of
the erase prevention tabs on the cassette is missing.
Refer to “ABOUT CASSETTE TAPES” on Page 22.
TAPE TO TAPE RECORDING (DUBBING)
To copy a previously recorded tape:
1.) Press “POWER” button to turn system ‘On’.
2.) Press “TAPE” button. The TAPE Indicator appears in the display.
3.) Press the “STOP/EJECT” key on both Decks to open the doors. Insert the
pre-recorded tape in Deck B and the blank tape in Deck A with exposed tape
facing down and full reels on the left. Close the cassette doors.
4.) Press the “PAUSE” key and the “RECORD” key on Deck A. Then press the
“PLAY” key on Deck B. The Deck A “PAUSE” key will release automatically
and both tapes will start simultaneously. All the material on the pre-recorded
tape in Deck B will be copied onto the blank tape in Deck A.
RECORDING HINT: Try to use a blank tape that is the same length or just slightly
longer than your pre-recorded tape. This will enable you to fit all the material on the
copy without excessive ‘blank space’.
HIGH SPEED DUBBING
When copying from tape to tape, you can reduce the recording time by pressing
the “HIGH SPEED DUBBING” button to the ‘On’ position ( ON OFF). Both
tapes will move at approximately 2 times the normal speed to cut the recording
time in half.
NOTE:Turn volume down to avoid unpleasant high speed sound.
MS9923TT_ib_0416.p65 16/4/2002, 14:18 21