EverFocus HD CCTV EQH5000 - Manual (Page 25)

26
9. OSD MANUAL
- USER SET
Using Set button, display [USER SET] sub menu.
- COMM/GPIO SET
Using Set button, display [COMM/GPIO SET] sub menu.
- FOCUS MODE
In focus mode, the iris becomes fully open, electronic shutter controls the light
level, and the TV out screen zooms into the center in order to make focusing
easier. When in Focus Mode, the OSD Menu is not displayed. The OSD Menu can
be toggled on and off using the Left / Right button.
- LANGUAGE
Select OSD Language. (Only English is available, currently)
• USER SET (Sub Menu)
- SAVE USER SET
Saves a copy of the current configuration set by the user into
a separate memory area. If user set data has been saved,
an [O] mark is displayed and if not, an [X] mark is displayed.
User Set settings can NOT be loaded automatically when
the camera is powered on. They can only be loaded
manually via the “LOAD USER SET” OSD choice. To make
the values in a User Set become the configuration loaded
when the camera is powered on, first load that User set,
then choose “SAVE AND EXIT” in any of the OSD Screens;
the current User Set OSD Settings will be written to the
power on configuration. These steps effectively copy a User
Set to the power on configuration.
- LOAD USER SET
Load the saved user set, and applies to Camera.
- CLEAR USER SET
Clear all saved user set.
- FACTORY RESET
Clear all setting and initialize to factory setting.
Clear user set.
- CAMERA RESET
Reboot the Camera.
FOCUS MODE OFF FOCUS MODE ON
> TV Out Image
[ USER SET ]
SAVE USER SET
LOAD USER SET
CLEAR USER SET
FACTORY RESET
CAMERA RESET
ESC
EXIT
[X]