Troubleshooting, Problems during recording – Edirol R-09 User Manual

Page 92

Advertising
background image

92

Troubleshooting

This section provides tips on solving problems that may occur.

The recording only plays on the L channel (left)

• If using an external microphone, check whether the microphone is set to stereo or monaural.

If the microphone is a monaural one, only the L channel (left) is recorded.

To record both channels using a monaural microphone, set the microphone type to “MONO”

using the [EXTERNAL MICROPHONE TYPE Switch].

“EXTERNAL MICROPHONE TYPE switch” (p. 9)

Recording won’t start

• Check the amount of space available on the memory card.

Recording is impossible if there is less than 16 KB available. Recording standby cannot be

entered either.

“Estimated recording times” (p. 28)

Can’t use the microphone

• When using the [Internal MIC], do not connect anything to the other input jacks. If a

microphone, cable, or device is connected to the [MIC Input Jack] or [LINE IN Jack], the

[Internal MIC] cannot be used.

“MICROPHONE INPUT jack” (p. 8), “LINE IN jack” (p. 8), “Using the internal microphones” (p.
29)

• When using an external microphone, please connect to the [MIC Input Jack] only. If a

microphone, cable, or other device is connected to the [Line In Jack], then the input from the

[MIC Input Jack] is ignored.

“MICROPHONE INPUT jack” (p. 8), “LINE IN jack” (p. 8), “Using external microphones” (p. 33)

• When using an external microphone, make sure to choose the settings appropriate for the

microphone being used.

“Set the type of microphone being used.” (p. 35)

• Is a phantom powered microphone connected

?

The R-09 does not support phantom powered microphones.

The recording is distorted

• Sound becomes distorted if the input level is too high. Set the input level to an appropriate

value.

“Adjusting recording levels” (p. 37)

Problems during recording

R-09_e.book 92 ページ 2007年2月13日 火曜日 午後3時27分

Advertising