Emerson EV477 - Manual (Page 34)

ON-SCREEN TIMER PROGRAMMING (CONTINUED)
When setting the Programmable Timer care should be taken to prevent the times from overlapping. If one
preset time starts before a program that is being recorded has finished, the recording of the first program will
be continued. After the first recording, the recording of the second program will be started.
The diagram below illustrates this point.
When the loaded cassette does not have a safety tab in place in the Timer Stand-by mode, the “ ” will
appear on the display panel and then a cassette without a safety tab will be ejected
automatically.
The TIMER indicator “ ” only disappears when you press the POWER key during the timer recording
process.
OVERLAPPING TIMER RECORDINGS
TIMER PROGRAMMING ERROR INDICATOR
33
Prog. 1 Prog. 2 Prog. 3
11:00 10:00 9:00 8:00
Program 1
Program 2
Program 3
Material
Actually Recorded
Deleted Parts
NOTE:
When the “ ” indicator is displayed in the timer Stand-by mode, the VCR cannot be operated
manually as no keys will operate in the Timer Stand-by mode.
To release the Timer Stand-by mode, press the Power key and use the VCR as usual.
Pressing Power key again will return the VCR to Timer.