Heath Zenith SL-6164 - Manual

© 2003 DESA Specialty Products™ 595-5707-04
Your doorbell includes:
• Doorbell chime
• Doorbell button/transmitter w/battery
• Hardware pack
You'll need to buy 3 "D" alkaline batteries for the chime. In typical use,
alkaline batteries will last up to three years.
3.
Before mounting, test the doorbell range. Put the
chime where you want to mount it and temporarily
place the doorbell button on the doorjamb. Press
the doorbell button.
2.
Install the 3
alkaline "D"
b a t t e r i e s .
Make sure
the batteries
are oriented
properly.
Operation
Press the doorbell button to verify that the doorbell and chime work prop-
erly. If the chime does not sound see the Troubleshooting guide on page 5.
Model SL-6164
Wireless
Musical
Chime
1.
To open the chime case:
Press in both catches on
the bottom of the chime
and lift the case open.
Battery Battery
Battery
Chime Volume
4.
Mount the doorbell button and chime.
Use either screws or double sided tape to mount the doorbell button.
To mount with screws, remove the back of the case by lightly pushing in the
tab on the bottom with a small screwdriver and rotating the blade.
Attach the back of the case to
the door jamb or wall. Snap the
front of the button back on.
When attaching the doorbell but-
ton using the double sided tape,
make sure the surface of the
door jamb or wall is clean.