Heath Zenith SL-6164 - Manual (Page 3)

-3- 595-5707-04
Code Settings
Note: Most installations will not require you to change any of the jump-
ers on your doorbell.
The doorbell button and chime communicate by using a code that can be changed
by removing and/or adding jumpers on both the doorbell button and chime. The
code is factory set; however, there are 128 selectable codes that allow you to
expand your system and prevent outside interference. Another wireless doorbell
system or other wireless products may cause interference and the system may
not function properly. Follow the instructions below for setting a new code.
1. Disconnect the power to the doorbell button and chime.
2. Open the cases and locate the jumpers on both the doorbell button and
chime (See illustration).
3. The doorbell button and chime both have eight different jumper locations.
The jumper positions 1 through 7 are used for setting the code.
4. To change the code, add and/or remove jumpers as needed. There are
128 different combinations. It is recommended to only change one jumper
at a time and then check to see if system is functioning properly. Note:
Jumpers in positions 1 through 7 must be exactly the same for both the
doorbell button and chime for this system to function.
Note: Models that have doorbell buttons for both front and back doors, the
back door must use the Ding tune and the front door may use any tune from
the Musical Chime Song List (see page 4).
ery Battery
ery Battery
B Battery
12
345
6
7
8
12
3
4
5
678
Doorbell Button Battery Replacement
Install an alkaline type A23 12 Volt battery. The
positive terminal should be positioned as shown.
* Code Settings 1-7
Must Match Both
Doorbell Button
and Chime
Inside
Doorbell
Button
Inside Chime
No Jumper
Necessary
Add jumper for back door
Ding or remove for front
door Music Selection
(for models with 2
doorbell buttons only)