HP 372284-001 User Manual
Page 33
Advertising
Firmware Upgrade Utility
5. Click
Next to perform the upgrade. As the Upgrade proceeds, status messages appear in
the Status Messages panel, and the progress toward completion is shown on the Progress
bar.
After the upgrade has completed, a screen appears to inform you that the procedure was
successful.
NOTE: If the Upgrade Succeeded screen does not appear, the upgrade failed to complete, and
you should repeat the upgrade procedure.
6. Click
Finish to close the Firmware Upgrade Utility.
7. Power off the switch by unplugging the KVM cable that you connected to the switch rear
panel in step 5 of the “Before You Begin” section.
8. Disconnect the RJ-11 firmware upgrade cable.
4-6
HP 1x4 USB/PS2 KVM Switch User Guide
Advertising