Installing your refrigerator – haier HB21FC75 User Manual

Page 6

Advertising
background image

English

InstallInG YoUR RefRIGeRatoR

4

note: this refrigerator is designed for freestanding installation

only. Make sure all air circulation guidelines are followed.

Unpacking Your Refrigerator

1. Remove all packaging material. This includes the foam base and all adhesive

tape holding the refrigerator accessories inside and outside.

2. Inspect and remove any remains of packing, tape or printed materials before

powering on the refrigerator.

Proper air Circulation

• To ensure that your refrigerator works at the maximum efficiency, you should

install it in a location with proper air circulation, plumbing and electrical

connections.

• The following are recommended clearances around the

refrigerator:

Sides…………….1" (25mm)

Top....................1" (25mm)

Back..................1" (25mm)

electrical Requirements

• Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with

proper grounding to power the refrigerator.

• Avoid the use of three-plug adapters or cutting off the third grounding in order

to accommodate a two-plug outlet. This is a dangerous practice since it

provides no effective grounding for the refrigerator and may result in

shock hazard.

Use of extension Cord

• Avoid the use of an extension cord because of potential safety hazards under

certain conditions. If it is necessary to use an extension cord, use only a 3-wire

extension cord that has a 3-blade grounding plug and a 3-slot outlet that will

accept the plug. The marked rating of the extension cord must be equal to, or

greater than, the electrical rating of the appliance.

Install limitations

• Do not install your refrigerator in any location not properly insulated or heated,

e.g. garage etc. Your refrigerator was not designed to operate in temperature

settings below 55˚ Fahrenheit.

• Select a suitable location for the refrigerator on a hard, even surface away

from direct sunlight or heat source, e.g. radiators, baseboard heaters, cooking

appliances etc. Any floor unevenness should be corrected with the leveling legs

located on the front bottom corners of the refrigerator.

Advertising
This manual is related to the following products: