Hampton Direct H200 - Manual (Page 18)

Hampton H200 Cast Freestanding Woodstove 18
DOOR REMOVAL
INSTALLATION
BRICK INSTALLATION
Firebrick is included to extend the life of your
stove and to radiate heat more evenly. Check
to see that all fi rebricks are in their correct
positions and have not become misaligned
during shipping.
Spring Lever
1) Open door.
2) Push spring lever down while holding onto
the door.
3) Pull door down and lift out to remove. Bottom
of door lifts right out.
Bottom part
of door fi ts
into slot.
Optional Ash Plug shown.
OPTIONAL SHORT LEG
INSTALLATION
1) Remove the cast lid from the top of the
stove.
2) Remove fan, if installed.
3) Carefully lay the unit on it's back on a soft
surface to prevent scratching.
4) Remove the 4 standard legs by undoing the
bolts.
Standard
Leg
5) Secure the 4 short legs using the bolts
removed from step 4.
Short Leg
6) Carefully bring stove to standing position.
7) Place cast lid back on top of stove.
8) Re-install fan, if removed.
9) Place decal 918-700 (included with cast
legs) on the back of the stove near the serial
number decal.