V ~ a – Harbor Freight Tools 12" Compound Slide Miter Saw 91852 User Manual
Page 11
SKU 91852
For technical questions, please call 1-800-444-3353.
PAGE 11
SYMBOLOGY
V ~
A
xxxx/min.
no
Double Insulated
Canadian Standards
Association
Underwriters
Laboratories, Inc.
Volts Alternating
Current
Amperes
No Load Revolutions
Per Minute (RPM)
UNPACKING
When unpacking, check to make sure all the parts shown on the
Parts Lists on pages 23
and 26 are included. If any parts are missing or broken, please call Harbor Freight Tools
at the number shown on the cover of this manual as soon as possible.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagrams on pages 25 and 26.
To Replace And Install A Saw Blade:
1.
WARNING! Prior to performing any assembly and/or adjustment
procedures, make sure the Power Cord (27) of the Miter Saw is unplugged
from its electrical outlet. Make sure the unit has completely cooled, and
wear heavy duty work gloves.
2.
When replacing the Saw Blade (4), make sure the new Saw Blade has a
diam-
eter of 12”, an RPM rating of at least 5000, and an arbor hole of 1” diameter.
3.
When installing a Saw Blade (4), make sure the teeth of the Saw Blade point
downward, and that the direction of the arrow shown on the Saw Blade matches
the direction of the arrow shown on the Blade Case (54).
(See Figure D.)