Harbor Freight Tools 12" Compound Slide Miter Saw 91852 User Manual
Page 17
SKU 91852
For technical questions, please call 1-800-444-3353.
PAGE 17
SWITCH LEVER
(41)
SAFETY BUTTON
(37)
FIGURE M
The Laser Assembly:
1.
The Miter Saw is equipped with a Laser Assembly (148) for improved cutting ac-
curacy and convenience.
(See Figure N.)
2.
The Laser Assembly (148) is powered by two “AAA” Batteries (included). To in-
stall the Batteries, open the Battery Box Cap (137). Insert two AAA Batteries into
the Battery Box (143), making sure to match the polarity of the Batteries with the
polarity signs (+ and -) as shown in the Battery Box.
(See Figure N.)
3.
To activate the Laser Assembly (148) depress the Laser Switch (136). Align the
cut line on the woodstock with the Laser Beam. Then, turn on the Miter Saw and
make the cut.
NOTE: Turn on the Laser only before you are ready to start cut-
ting, and make sure the Laser Assembly is off when not cutting.
(See Figure N.)
4.
To adjust the Laser, loosen the retaining screw (located in a slotted hole in the
laser housing). With the screw loosened, the laser may be pivoted left/right for
proper alignment. Then retighten the screw. Note: Use a #1 Philips screwdriver.
LASER ASSY.
(148)
LASER SWITCH
(136)
BATTERY BOX
(143)
FIGURE N
REV 03/06, REV 08i, 08k