Handspring Visor - Manual (Page 18)

Page 18 Introduction to Your Visor™ Handheld
Installing the batteries
To use your handheld, you must install two AAA alkaline batteries.
The batteries fit behind the battery door on the back of the handheld.
See “Battery considerations” in Appendix A for more information.
To install the batteries:
1. Press the latch on the battery door and lift the battery door away
from your handheld.
2. Install the two AAA alkaline batteries supplied with your
handheld into the battery compartment.
Note: A diagram in the interior of the battery compartment
shows + and - ends of the batteries. When correctly
installed, the clips in the battery compartment secure the
batteries in place.
3. Insert the battery door back into place so that it is flush with the
back of your handheld and “clicks” into position.
Important: Do not force the battery door. When the batteries are
correctly installed, the battery door clips smoothly into
place. If you feel resistance when replacing the door,
make sure the door is aligned with the slots on the back of
your handheld, and that the batteries are firmly seated in
the battery compartment.